23099 Connecticut Street
Hayward, CA 94545
Phone: 510-785-9148
Fax: 510-785-0466
Machining
Our in-house Machining capabilities include, but are not limited to, the following:
- Trimming
- Facing
- Drilling
- Slotting
- Piercing
- Flattening
- Turning
|
- Boring
- Coping
- Sizing
- Expanding
- After bend end forms
- Assembly Work
- Prototype
|
Our Machining Equipment
- (4) Manual Bridgeport type Knee Mills, with 3 axis DROs
- (4) Hydraulic Tube Sizing Stations
- (1) 14” Gap Bed Engine Lathe
- (1) 100 Ton Hydraulic Press
- (1) Power Feed Drill Press
- (1) 55 Ton Tooled Iron Worker
|
- (1) Hydraulic Sheet Metal Shear (14” capacity)
- (2) Manual Feed Turntables (16”)
- (2) 90 Degree Right Angle Milling attachments
- (1) Cold Saw
- (4) 18” Capacity Band saws
- (1) 18” Automatic Series 81 Band saw
|
In-House Tooling
Our staff of experienced toolmakers can build custom bend tooling, to complex assembly fixtures to support your special needs.
Value added services include:
- In-house Bend Tooling ranging from .062 to 1 ½-inch Diameter
- Metric Tooling
- Compound tangent-to-tangent tooling
- Compensated spring-back corrected bend tooling.
- Step pressure dies
- Go / No Go gage tooling
- Trim fixtures
|
- Aerospace Quality Bend / Inspection fixtures
- Expansion tooling
- Flattening tooling
- Assembly fixtures
- Extrusion tooling
- Swage tooling
- Pressure test tooling
- Short lead / small run tooling
|
