top of page

Machining

Our in-house Machining capabilities include, but are not limited to, the following:

  • Trimming

  • Facing

  • Drilling

  • Slotting

  • Piercing

  • Flattening

  • Turning

  • Boring

  • Coping

  • Sizing

  • Expanding

  • After bend end forms

  • Assembly  Work

  • Prototype

Our Machining Equipment

•    (7)  Manual Bridgeport type Knee  Mills and SuperMill, with 3 axis DROs                           
•    (4) Hydraulic Tube Sizing Stations
•    (2) 14” Gap Bed  Engine Lathe
•    (1) 100 Ton Hydraulic Press
•    (2) Power Feed Drill Press

  •  (1) 55 Ton Tooled Iron Worker

  • (5) Cold Saw

  • (4) 18” Capacity Band saws

  • (1) 18” Automatic Series 81 Band saw

  • (1) Automatic Cold Saw

 

In-House Tooling

Our staff of experienced toolmakers can build custom bend tooling, to complex assembly fixtures to support your special needs.

Value added services include:

  • In-house Bend Tooling ranging from .062 to 1 ½-inch Diameter

  • Metric Tooling

  • Compound tangent-to-tangent tooling

  • Compensated spring-back corrected bend tooling.

  • Step pressure dies

  • Go / No Go gage tooling

  • Trim fixtures

  • Aerospace Quality Bend / Inspection fixtures

  • Expansion tooling

  • Flattening tooling

  • Assembly fixtures

  • Extrusion tooling

  • Swage tooling

  • Pressure test tooling

  • Short lead / small run tooling

042 (1).gif

01/19 - 01/23

Click here to add your own content, or connect to data from your collections.

picture073 (1).gif

01/19 - 01/23

Click here to add your own content, or connect to data from your collections.

041 (1).gif

01/19 - 01/23

Click here to add your own content, or connect to data from your collections.

bottom of page